[Pre-Order] Wirentech 12kW Hybrid Solar Inverter for Home Energy Storage

This product describes one Wirentech 12kW 120/240V split-phase hybrid inverter in the standard enclosure. Batteries, solar panels, generator equipment, a separate 200A bypass enclosure, breakers, disconnects, cables, and other system components are not included unless the exact product listing states otherwise. Confirm the full model suffix and included accessories before ordering.

Yes. The inverter provides 120/240V split-phase output for compatible home or ranch circuits. Total continuous output is 12kW, while loading assigned to a single phase is limited to 7.2kW. Plan phase balance, simultaneous demand, and motor starting current with a qualified installer.

The inverter provides 12kW of continuous output and up to 18kVA of peak power, with 10ms typical transfer and motor-starting capability up to 6HP under the specified conditions. Verify the running watts and starting surge of every connected load instead of sizing from rated output alone.

No 200A bypass claim applies to the standard enclosure shown here. A 200A grid-bypass path belongs to a separate bypass-equipped enclosure or product configuration and is not the same as 12kW battery-mode inverter output. Verify the exact enclosure and listing before ordering.

PV input depends on the exact suffix. The M220 class is documented for 6kW plus 6kW, the M250 class for 9kW plus 9kW, and the M250X class for 12kW plus 12kW. All three list a 90–450V MPPT range and 500V maximum open-circuit voltage. These are electrical limits, not promised production or recharge times.

Yes. The hybrid platform can coordinate solar input, grid charging, generator charging, and battery storage for solar self-use, scheduled charging, outage reserve, and multiple recovery paths. Final source configuration, transfer logic, and charging settings must follow the exact inverter manual and applicable electrical codes.

The inverter is designed around a 51.2V nominal battery platform with a documented 40–58.6Vdc operating range and 44V minimum start voltage. The listed maximum AC charging current is 160A, while maximum PV charging is 220A or 250A depending on the suffix. Confirm continuous and surge current capability, BMS protocol, and charge settings before connection. USB and RS485 communication are supported.

Manual-documented safeguards address overload, short circuit, PV reverse polarity, AC reverse conditions, overvoltage, and temperature. These internal functions do not replace correctly sized breakers, fuses, disconnects, conductors, grounding, ventilation, or professional installation.

Parallel operation applies only to documented P or XP suffix versions, with configurations of up to six units. Base and X versions must not be assumed to support parallel operation. Verify the complete model number, parallel accessories, communication requirements, and installation instructions before ordering or commissioning.

Verify the split-phase circuit plan, phase balance, battery current capability, PV class, generator configuration, parallel suffix, conductor sizes, protection devices, airflow, and wall support. The standard inverter measures 620 × 450 × 132 mm, weighs 23.8 kg or 52.5 lb, and has a listed operating range of -10°C to 55°C. A 5-year limited inverter warranty applies under its terms.